·It is required to provide a standard equipment hole for each riveting fastener.
·It is required to ensure that the bottom end (or guide groove) of rivet fastener is in the equipment hole before applying equipment force.
·It is required to apply a fastening force between parallel faces. The fastening force is used to fix the fastener during operation and to ensure the resistance to torsion during equipment operation.
·It is required to apply satisfactory equipment force to make the fastening ring fully embedded along the entire circumference and make the convex surface just contact with the plate.
·Do not use equipment steel or stainless steel fasteners before anodizing or surface treatment of aluminum plates.
·Do not remove the burr around the fastener before the equipment is riveted - because removing the burr will consume the metal used to fasten the fastener and plate.
·Do not press the fasteners closer to the edge of the plate at the interval of the Z short edge in this table. (In addition to using special clamps to avoid arching of the edge of the plate).
·Do not over knead as this will flatten the head, distort the threads and bend the plate. Before mass production, the best Z equipment force should be determined through experiments.
·Do not try to use a hammer to equipment fasteners. The hammer will not make the plate move smoothly and interlock with the fastener.
·Do not screw from the head of the fastener, but from the opposite side of the fastener head, so that the force of the fastener faces the plate.
·Do not rivet fasteners on the precoating equipment of the plate.